FS FORCE

Posted: **Tue May 10, 2011 2:31 am**

I'm exploring the strategy of using a MS-SW-FFB2 and Saitek Evo..
I use the SW as to control the ailerons and elevator (cyclic) I like the feel of the MSSW a lot, BUT I use the Evo to control the throttle (collective) its bigger and better than that little slider.. I get to use both sets of buttons..
.. the trim is with the MS...

There's no overlap between the controls from each stick.. and it works fine but it's the saitek evo which responds to the bumps etc !! the joystick test is done on the MSSWFFB2...

any ideas.. BTW I dont mind much..but

Is there some where I should be fiddling things..

Posted: **Tue May 10, 2011 3:23 am**

To set the MSFF2 as the preferred controller, you have to make an entry in the C:\ProgramData\FS Force\fsforce.cfg file. Visit the getting started page of the docs (http://www.fs-force.com/help2/getting_started.htm) and look towards the bottom for the section entitled Multiple Joysticks.

Posted: **Tue May 10, 2011 3:42 am**

That was fast Russ.. Thanks..
As usual read the manual!
regards

Posted: **Tue May 10, 2011 4:01 am**

Hey ho Russ.. I've read the manual..
I cant find the file FSForce.cfg

I'm using windows 7.. BUT I havent bought it yet.. does that make a difference?

Posted: **Tue May 10, 2011 5:01 am**

If you've installed the demo, it should be in C:\Programdata\FS Force.

Posted: **Tue May 10, 2011 1:50 pm**

Thank you Russel.. of course it was..
sorry..my brain had stopped..

But so far I can see the support for the product works fine!

I'll test out the 'product' later!
regards

FS FORCE

two joysticks..

two joysticks..