HAT Switch trim sensitivity on MS FFB2
Posted: Fri Dec 24, 2010 4:19 am
Hello again. Just hoping for some quick advice, and to find out if this is an adjustable parameter.
I dumped my G940 and got a Microsoft FFB2. I love it. I've assigned up/down trim to the HAT switch and I noticed that it "repeats" rather quickly, with only a slight tap on the hat. Is it possible to reduce the quickness at which the HAT repeats the trim command? I'm finding it slightly touchy to dial in trim in 1 degree increments. Generally it skips ahead by 3-4 clicks per press.
If not, that's cool, I can usually get it lined up with a bit of quick, deliberate "tapping" of the button, but I was wondering if this was something I could adjust.
Thanks!
I dumped my G940 and got a Microsoft FFB2. I love it. I've assigned up/down trim to the HAT switch and I noticed that it "repeats" rather quickly, with only a slight tap on the hat. Is it possible to reduce the quickness at which the HAT repeats the trim command? I'm finding it slightly touchy to dial in trim in 1 degree increments. Generally it skips ahead by 3-4 clicks per press.
If not, that's cool, I can usually get it lined up with a bit of quick, deliberate "tapping" of the button, but I was wondering if this was something I could adjust.
Thanks!