FS FORCE

Hello,
I cannot have a valid FSForce active for 1 aircraft

I added the requested lines in the panel but without success.

What information do I need to provide to help solving this issue?
Thanks in advance.

Do you get any force feedback when you fly that plane? The message about the trim gauge is probably because that airplane has a non-standard panel and FS Force can't install the gauge.

I have had the same issue with Aerosoft's BeaverX. The trim gauge is not enabled but the force feedback works just fine. I just set my trim for takeoff using the aircraft's trim idicator. Once in flight you really don't need the indicator as you just trim to remove control pressures. I also tried manually editing the panel.cfg and Kirk took a shot at it too but no joy. If you figure out afix please post it here. Good luck.