Cannot have FSForce working for 1 airdraft

Emile · Post by **Emile** » Wed Mar 21, 2007 2:56 am

Hello,
I cannot have a valid FSForce active for 1 aircraft

I added the requested lines in the panel but without success.

What information do I need to provide to help solving this issue?

Thanks in advance.

Post by **RussDirks** » Wed Mar 21, 2007 5:56 am

Do you get any force feedback when you fly that plane? The message about the trim gauge is probably because that airplane has a non-standard panel and FS Force can't install the gauge.

dbrucem · Post by **dbrucem** » Sat Mar 31, 2007 6:16 pm

I have had the same issue with Aerosoft's BeaverX. The trim gauge is not enabled but the force feedback works just fine. I just set my trim for takeoff using the aircraft's trim idicator. Once in flight you really don't need the indicator as you just trim to remove control pressures. I also tried manually editing the panel.cfg and Kirk took a shot at it too but no joy. If you figure out afix please post it here. Good luck.